Remote Control
LS7+72V: If your scooter does not support app-based lighting control, you will need to purchase and install a separate LED strip controller to enable control via an app-compatible remote.
To pair the devices, turn on the light strip and hold down the "W" button on the remote control. When the light turns white, pairing is complete.
Merci, Nanrobot mΓͺme si les piΓ¨ces coΓ»te cher, elle sont de qualitΓ© et disponible tout le temps ! La tΓ©lΓ©commande fonctionne parfaitement !
Received order #19609 of box with no problem for my ls7+.
I wish I could give this 5 stars but I have ordered two of these to replace the original for my Ls7+ 72v and unfortunately neither has worked. I am knowledgeable in electronics and found the controllers will only lock the leds on my scooter in stationary rainbow mode no matter what button is pressed. I held down W turned off LED main button on scooter and then back on while holding W but when I do the LEDs only remained off until I switched main off and on again . I love my scooter but I am out fifty something dollars for the controllers . I gave up trying to message the service as I am far too busy to only troubleshoot via email and they want you to send them videos of what you do to fix it on what's app which I absolutely will not use . I understand the steps they go through as some people are not tech savvy but I have been micro soldering chips, motherboards and RF receivers like the one in this scooter for 20+ years so when they ask me to make sure I removed the plastic tab from the battery compartment before using it .... it's difficult to not get annoyed . I will just have to put my own receiver on the existing LEDS and use a different remote . It's too bad though as I like some of the modes that were available with the stock one . Oh well .